Zanussi Electrolux Gas hobs Manual de servicio descargar pdf (Pagina 15)

11. REPLACEMENT OF

COMPONENTS

(Only to be carried out by an authorized installer).

REMOVE THE TOP CONTROL PANEL:

— GAS COCK

• Remove the thermocouple.

• Remove the gas inlet/outlet connections.

— MAIN BURNER

• Remove the injector support gas pipe.

• Slacken the hob burner fixing screws.

— THERMOCOUPLE, SPARK ELECTRODE.

• Remove the component fixing brackets and replace.

— GAS OVEN THERMOSTAT COCK

• Remove the pilot burner pipe and thermocouple.

• Remove the gas inlet/outlet connections.

• Remove the bulb from its seat by detaching it from inside the

oven.

REMOVE THE OVEN BASE

— MAIN BURNER

• Remove the injector support gas pipe and fixing screws.

When re-assembling the burner, take care to insert the rear

alignment pin in the correct seat.

— PILOT BURNER

• Remove the oven base via the bottom control panel and inside

of the oven.

FOR THE INSTALLATION OF COMPONENTS, FOLLOW THE

SAME PROCEDURE IN REVERSE ORDER.

1 2 ... 10 11 12 13 14 15 16 17

Sin comentarios

Zanussi Electrolux Gas hobs Manual de servicio Pagina 15