Zanussi-Electrolux ZGF68XE Manual de usuario descargar pdf (Pagina 9)

Conversion from LPG to Natural Gas

IMPORTANT

The replacement/conversion of the gas hob should only

be undertaken by a competent person.

It is important to note that this model is designed for use

with LPG gas but can be converted for use with Natural

gas providing the correct injectors are fitted and the gas

rate is adjusted to suit.

Replace the rating label (placed near the gas supply pipe)

with the relevant one for the new type of gas supply. You

can find this label in the package of the injectors supplied

with the appliance.

Method

• Ensure that the gas taps are in the 'OFF' position

• Isolate the hob from the electrical supply

• Remove all pan supports, burner caps, rings, crowns

and control knobs.

• With the aid of a 7mm box spanner the burner injectors

can then be unscrewed and replaced by the

appropriate Natuaral gas injectors.

To adjust the gas rate

To adjust the minimum level of the burners, proceed as

follows:

• Light the burner.

• Turn the knob on the minimum position.

• Remove the knob.

• With a thin screwdriver, adjust the by-pass screw.

If changing from LPG to natural gas unscrew about

1/4 turn the by-pass screw, until a small regular flame

is obtained.

If changing from natural gas to LPG, completely

tighten clockwise the screw, until a small regular

flame is obtained.

• Finally check the flame does not go out when quickly

turning the knob from the maximum position to the

minimum position.

This procedure can easily be carried out, anyhow the

hob has been positioned or built in the working top.

Commissioning

When the hob has been fully installed it will be necessary

to check the minimum flame setting. To do this, follow

the procedure below.

- Turn the gas tap to the MAX position and ignite.

- Set the gas tap to the MIN flame position then turn

the control knob from MIN to MAX several times. If

the flame is unstable or is extinguished follow the

procedure below.

Procedure:

- Re-ignite the burner and set to MIN.

- Remove the control knob and use a thin bladed

screwdriver to turn the adjustment screw until the flame

is steady and does not extinguish, when the knob is

turned from MIN to MAX.

- The adjustment screw may be located at the centre

of the gas tap control shaft or on the gas tap body,

left of the control shaft or below (see diagram).

- Repeat the adjustment procedure for all burners.

Adjustment

screw

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comentarios a estos manuales

Sin comentarios

Zanussi-Electrolux ZGF68XE Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Zanussi-Electrolux ZGF68XE